People who may often contact with the colored steel tile always hear the master say that one piece of cloth and three coats is very important. As long as one piece of cloth and three coats is made, the construction quality has basically decided half. At this point, you may think, what is this cloth, three coats? It is so important. Let's talk about it in detail.

　　布:

　　Cloth:

　　在涂刷前，需要对彩钢瓦的中空部分进行填充，先用合成高分子防水涂料对中空的表面进行涂刷，再用聚酯无纺布对中空部位进行粘贴。

　　Before painting, the hollow part of the color steel tile needs to be filled. First, the hollow surface is painted with synthetic polymer waterproof coating, and then the hollow part is pasted with polyester non-woven fabric.

　　三种涂层:

　　Three coatings:

　　1,外套

　　1, coat

　　在彩钢瓦到20厘米宽的位置加入1020厘米的接缝处刷涂防水涂料，要均匀、厚度一致，然后还要检查一下是否有空泡，假如有话就要进行修理，然后可以进行下一道工序。

　　Add 10-20cm waterproof coating at the joint of color steel tile to 20cm wide, evenly and with the same thickness, and then check whether there is any void, if so, repair it, and then carry out the next process.

　　2、在涂层中

　　2. In the coating

　　是刷防水涂料聚酯非织造布,上面覆盖着瓷砖,厚度应均匀,涂层的厚度应控制在大约0.4毫米,表面干燥后,可以试着用手触摸表面,看看粘手,请勿触摸的话可以进行3刷涂料。

　　It's Polyester nonwovens with waterproof coating, which are covered with ceramic tiles. The thickness of the coating should be uniform. The thickness of the coating should be controlled at about 0.4mm. After the surface is dry, you can try to touch the surface with your hands to see if it's sticky. If you don't touch it, you can brush the coating for three times.

　　3、表面涂层

　　3. Surface coating

　　采用彩钢瓦专用高分子防水涂料，采用油漆刷进行刷涂，即使是油漆刷，也没有流滴。刷后厚度0.3mm。

　　The special polymer waterproof coating for color steel tile is used, and the paint brush is used for brushing, even if the paint brush is used, there is no dripping. The thickness after brushing is 0.3mm.

　　这是一块布的整个内容三涂,因此相信我们还可以看到,施工的施工质量颜色钢瓦的确是一个非常重要的角色,所以在施工操作中,必须认真操作,以避免影响施工质量的可能性的布三涂,因为他们的操作不当。并提醒大家，整个涂料表面可以在2小时6小时内干燥，但需要24小时才能完全干燥，这一点一定要注意。

　　This is the third coating of the whole content of a piece of cloth, so we can see that the construction quality and color of steel tile is indeed a very important role, so in the construction operation, we must operate carefully to avoid the third coating of cloth that may affect the construction quality, because they operate improperly. And remind everyone, the whole coating surface can be dried in 2 hours to 6 hours, but it takes 24 hours to completely dry, this must be noted.